Baileigh WR-84V-ATC, Руководство оператора

Страница: 17 / 56

15
15
•
Remove scrap and waste materials, make sure the work area is free from obstructions.
•
It is important to maintain free area around the machine, which is required for the working
place. If any long material is machined, it is necessary to have a sufficient room in front of
the machine as well behind it in the places of material input and output.
•
LEVELING: The machine should be sited on a level, concrete floor. Provisions for securing it
should be in position prior to placing the machine. The accuracy of any machine depends on
the precise placement of it to the mounting surface.
•
FLOOR: This tool distributes a large amount of weight over a small area. Make certain that
the floor can support the weight of the machine, work stock, and the operator. The floor
should also be a level surface. If the unit wobbles or rocks once in place, be sure to eliminate
by using shims.
•
WORKING CLEARANCES: Take into consideration the size of the material to be
processed. Make sure that you allow enough space for you to operate the machine freely.
•
POWER SUPPLY PLACEMENT: The power supply should be located close enough to the
machine so that the power cord is not in an area where it would cause a tripping hazard. Be
sure to observe all electrical codes if installing new circuits and/or outlets.
GETTING TO KNOW YOUR MACHINE
This NC machine is designed to give you years of safe
service. Read this owner’s manual in its
entirety before assembly or use.
The advantage of the NC machine is that it can, in most cases, fully machine the complete job
without it being removed from the table, so that you have finished parts of high accuracy that are
extremely repeatable.
With the purchase of the relevant software, it can produce intricate carvings and / or nesting
which is also a valuable feature of NC machining that saves on waste and costs.
•
Bed . The bed of the machine consists of a heavy steel frame and a vacuum table top to hold
down the material to be cut.
•
Vacuum Top . The table top is divided into four hold down areas. Each area has an air inlet
connected to a shut-off ball valve. This gives the operator complete control as to where the
hold down system is turned on or off.
•
Gantry . The gantry straddles the bed and carries the router spindle motion system. It is
moved along the length of the bed by a precision rack and pinion system that is controlled by
the machine controller.
•
Router Spindle . The router spindle is moved along the gantry by a precision rack and pinion
system that is controlled by the machine controller.
•
Frame . The frame is a heavy welded construction that supports all the other parts of the
machine.