Baileigh WR-84V-ATC, Руководство оператора

Страница: 30 / 56

28
28
Start Up
1. Verify that the table surface is clear for the
spindle to move.
2. Verify that both the E-Stop buttons are
released.
3. Press the Power button and allow the
system to boot up.
4. When the message is displayed on the
hand-held control to
“Back to REF point”,
press OK.
5. Allow the head (spindle assembly) to return
to the Home position (shown). The Home
position is with the Head in the front left
corner of the table with the spindle fully
raised.
6. The system is now ready for operation.
Note
: This is described as starting from the Home position. Starting with the head
in other location about the table will only change the amount of movement remaining in any
specific direction.
7. Using the key pad, press the X+ and or Y+ to move the head around the table.
8. Pressing the (X+) or (X-) keys will move the head across the width of the table.
9. Pressing the (Y+) or (Y-) keys will move the gantry along the length of the table.
10. Pressing the (Z+) or (Z-) keys will raise and lower the spindle.
Setting Workpiece Coordinate
1. Load and secure the material to the table surface so that it will not move during the
machining process.
2. Using the X and Y coordinated keys, move the spindle over the highest position on the work
piece.
3. Using the Z- coordinate key, lower the spindle so that the tool tip just lightly contacts the top
surface of the work piece.