Baileigh WR-84V-ATC, Руководство оператора

Страница: 45 / 56

43
43
•
When the display
shows “ERP”, it means low system pressure. Check for pipe/tube
damage or leaks, or the lubrication cycle time is too short to develop a pressure reading.
•
When the display
shows “ERS”, it means that the system is running overtime.
AIR MISTER
The air mist system may be used to spray air at the cutting area or coolant using a siphon
system where the air draws the coolant into the block and then sprays the air coolant mixture at
the cutting area.
The K1 key turns the spray
valve on and off.
The larger input tube for the
air line.
The left (as pictured)
needle valve controls the
air flow.
•
Adjust the upper left
valve for air flow.
The smaller tube is for the
coolant line.
The right (as pictured)
needle valve controls the
coolant flow.
•
Adjust the lower right
valve for coolant flow.
This is a venturi based syphon system. No coolant will flow without air flow.
The coolant valve may be closed to spray only air if desired.
Air supply requirements:
9-10CFM @ 85psi.