Baileigh TS-1248P, Руководство оператора

Страница: 69 / 104

65
65
Basic Operation
The DRO is a linear measuring display with 2
measuring screens.
Press the ABS/REL button to move between
the two screens.
The ABS screen is a measurement based
upon a zero point, (usually tight to the blade),
that requires several key strokes to set to zero
to prevent accidental zeroing.
The REL measurement is considered a soft
reset and may be reset at any time the REL
screen is active by pressing the Zero/Enter
button.
Note: The DRO will need to be
re-zeroed on a frequent basis, such as whenever the fence was removed.
1. Disconnect and lockout power to the saw!
2. Press the mm/inch button to select between millimeters or inch measuring.
3. Unlock the fence and slide it up to the blade. Be sure to lift the blade guard and the anti-
kickback pawl.
4. If the standard fence is used (not an auxiliary or sacrificial fence) the fence scale should also
read zero.

If the fence scale does not read at the zero mark, follow the fence scale calibration
procedure.
5. If needed, press the ABS/REL button to show the REL screen.
6. Press the Zero/Return button to zero the REL position of the DRO.
The DRO is now ready to display the measurement for distance the fence has moved from the
zero point.
If for any reason the operator presses the Zero/Enter button whether accidentally or by choice,
the DRO will reset the REL position to zero.
ZERO/ENTER FUNCTION
The Zero/Return button will either accept the option as shown on the screen or
change a numerical value to zero. This button is active in all screens.