Baileigh TS-1248P, Руководство оператора

Страница: 51 / 104

47
47

DO NOT make through cuts with a dado blade. Dado blades are only intended for non-
through cuts. Failure to heed this warning could result in serious injury.

Never try to dado a warped board by holding it down against the table. If kickback occurs,
your hand could be pulled into the blade, resulting in accidental contact with the rotating
blade, causing lacerations or amputation.
Cutting Dadoes with a Dado Blade
Use a sequential process of making multiple, light cuts that get progressively deeper. The actual
number of cuts used should be determined by workpiece hardness, total dado depth, and feed
rate. In general, if you hear the motor slow down during the cut, you are cutting too deep or
feeding too fast.
1. Disconnect and lockout power to the saw!
2. Install the dado blade set to the desired width of cut and a dado insert.
3. Adjust the dado blade to the desired depth of cut, keeping in mind that you may need to
make several passes to complete the cut.
4. Align the workpiece to the dado blade to remove the waste material.

Use either the fence or the miter gauge to guide the material through the cut. NEVER use
both.

Adjust the distance between the fence and the inside edge of the blade to dado the length of
a workpiece.

Use the miter gauge and carefully line up the desired cut with the dado blade when dadoing
across the workpiece.

DO NOT use the fence in combination with the miter gauge, to prevent binding with the
workpiece.
WARNING:
NEVER use the dado head in a bevel position unless you
make your own dado insert!
ALWAYS install blade guard after operation is complete!
IMPORTANT:
Dado blades have a higher risk of kickback than normal
blades because their larger size applies stronger forces to the workpiece. This risk
increases relative to the depth and width of the cut. To minimize your risk of serious
personal injury, ensure that stock is flat and straight, and make multiple light cuts
(rather than one deep cut) to achieve the desired cutting depth.