Baileigh TS-1248P, Руководство оператора

Страница: 33 / 104

29
29

Large/Loose Knots: Loose knots can become dislodged during the cutting operation. Large
knots can cause kickback and machine damage. Choose workpieces that do not have
large/loose knots or plan ahead to avoid cutting through them.

Wet or "Green" Stock: Cutting wood with a moisture content over 20% causes
unnecessary wear on the blades, increases the risk of kickback, and yields poor results.

Excessive Warping: Workpieces with excessive cupping, bowing, or twisting are dangerous
to cut because they are unstable and may move unpredictably when being cut.

Minor Warping: Slightly cupped workpieces can be safely supported with cupped side
facing the table or fence; however, work-pieces supported on the bowed side will rock during
the cut, which could cause kickback.
BLADE REQUIREMENTS
To ensure that the spreader or riving knife works safely, the following requirements MUST be
met when installing new blades.
Blade Diameter:
12"
Required Blade Body Thickness (excluding teeth): 0.074
– 0.082” (1.9 – 2.1mm)
Required Blade Kerf Thickness:
0.114” – 0.122” (2.9 – 3.1mm)
The spreader or riving knife MUST be aligned/adjusted to blade.
These requirements DO NOT apply to dado blades.
BLADE SELECTION
This section on blade selection is by no means comprehensive. Always follow the saw blade
manufacturer's recommendations to ensure safe and efficient operation of your table saw.
Ripping Blade Features

Best for cutting with the grain

20-40 teeth

Flat-top ground tooth profile

Large gullets for large chip removal