Baileigh TS-1248P, Руководство оператора, Страница: 59 / 104

55
55
5. Loosen the cap screws and the jam nut (A).
6. Tightens the adjustment hex bolt slightly and recheck the backlash.
7. Proper backlash will be when no backlash is felt without being so tight as to bind the gears.
8. Hold the adjustment bolt in position and tighten the jam nut.
9. Close the motor access cover.
Blade Tilt Angle Digital Readout Calibration
The digital readout displays the current blade angle.
Note: When power is disconnected,
the digital display will automatically reset to 0.00.
When power is reconnected, the blade tilt angle
DRO needs to be calibrated.
To calibrate the digital readout:
1. Verify that the 90° and 45° blade tilt stops are
correctly positioned.
2. Connect power to the saw, but DO NOT turn
the saw on.
3. Move the blade angle to 90°.
4. Press and hold the 0° set button for several seconds until the readout displays 0.00, or move
the blade angle to 45° and press and hold the 45° set button until the readout displays 45.0.