Baileigh Industrial TS-1040E-1.0 30, Руководство оператора

Страница: 21 / 56

18
18
Extension Wings
7. Inspect the extension wings and main table mating
surfaces for burrs or foreign materials that may
inhibit assembly.
8. The mating edges of the wings and the table
must be clean, smooth, and flat, use a wire brush
or file if necessary to clean up the edges, this step
will ensure that the wings mount properly to the main
table.
9. Loosely attach the wings to the main table with the
M10 Flat washers, lock washers and M10 screws.
10. Place the straightedge across the extension wings
and main table to make sure that the table surface
is flat. Use soft surface clamps to assist as needed.
•
If the outside end of extension wings tilts down
or up, use a strip of masking tape to shim the
extension wing up or down.
•
Shim the top (above the holes) if the table is tilted upward, and shim the bottom (below
the holes) if the table is tilted downward.
11. When the tables are aligned, and flat across the entire surface, fully tighten the three M10
screws for each extension.