Baileigh Industrial TS-1040E-1.0 30, Руководство оператора

Страница: 40 / 56

37
37
Cleaning
Cleaning the saw is relatively easy. Vacuum excess wood chips and sawdust, and wipe off the
remaining dust with a dry cloth. If any resin has built up, use a resin dissolving cleaner to
remove it.
After cleaning, treat all unpainted cast iron and steel with a non-staining lubricant.
Occasionally it will become necessary to clean the internal parts with more than a vacuum. To
do this, remove the table top and clean the internal parts with resin/pitch dissolver or mineral
spirits and a stiff wire brush or steel wool.
Make sure the internal workings are dry before using the saw again, so that wood dust will not
accumulate. If any essential lubrication is removed during cleaning, re-lubricate those areas.
Lubrication
The table saw has sealed lubricated bearings in the motor housing and the arbor assembly, they
will not require any additional lubrication. Use a wire brush to clean off the worm gears and
trunnions and apply a white lithium grease to keep them lubricated.
Changing Belts
1. Make sure the power cord is disconnected from the
power source!
2. Lower the blade completely, and then open the
motor access cover.
3. Loosen the hex nuts that secure the motor (A) and
raise the motor fully to remove tension on the V-
belts.
4. Roll the V-belts off of the arbor and motor pulleys.
5. While continuing to raise the motor, install a new
matching set of V-belts onto the pulleys, lower the
motor to tension the V-belts, then tighten the hex
nuts.
6. Check V-belt tension.
7. Close the motor access cover.