Baileigh Industrial TS-1040E-1.0 30, Руководство оператора

Страница: 26 / 56

23
23
Install the Blade Guard and Riving Knife
1. Reinstall the insert, slide the knurled knob out
and rotate it forward so it engages the upper
bracket.
2. Slide the blade guard spreader all the way down
into the block, then rotate the knurled knob so it
disengages the bracket and the locking pin
engages the hole in the center of the spreader.
3. Give the spreader an upward tug to verify that it
is locked the blade guard. When properly
installed, it should look like Fig. on right, and
should pivot freely so it touches the table surface
in the down position. It should also swing up high
enough to accommodate the workpiece.
4. Adjust the level adjust screws to make sure the table insert is flush with the table.
5. Place a straightedge against the blade and the spreader. When properly aligned, the
spreader/riving knife will be in the "alignment zone," shown in Fig, and will be parallel with
the blade.
Insert Alignment zone
CAUTION:
After changing a saw blade, always check that the Riving
knife or Blade Guard is correctly set!