Baileigh Industrial TS-1040E-1.0 30, Руководство оператора

Страница: 38 / 56

35
35
Using Dado Blade Set and Dado Insert
Dadoing is cutting a rabbet or a wide groove into the
work.
Most dado head sets are made up of two outside blades
and four or five inside cutters.
Various combination of saws and cutters are used to cut
grooves fro
m 1/8” to 13/16” for use in shelving, making
joints, tenoning, grooving, etc.
The cutters are heavily swaged and must be arranged so
that this heavy portion falls in the gullet of the outside
blades.
The saw and cutter overlap (A) being the outside blade,
(B) and inside cutter, and (C) a paper washer which can
be used as needed to control the exact width of groove.
A 1/4” (6.3mm) groove is cut by using the two
outside blades. The teeth of the blades should
be positioned so that the raker on one saw is
beside the cutting teeth on the other saw.
The dado head set is assembled to the saw
arbor in the same manner as the saw blade.
Important: The guard splitter and
anti-kickback finger assembly cannot be used
during dadoing operations and must be
removed from the saw. The dado head table insert must be used in place of the standard table
insert during dado operations.
WARNING:
Blades are dangerously sharp. Use extreme caution when
working with or around the blade. Wear proper safety protection such as heavy
gloves.
WARNING:
NEVER use the dado head in a bevel position unless you
make your own dado insert!
ALWAYS install blade guard after operation is complete!