Baileigh Industrial TS-1040E-1.0 30, Руководство оператора

Страница: 34 / 56

31
31
Adjusting 45 and 90 Degree Positive Stops
The blade tilting mechanism of your saw is equipped with a positive stop at 45 and 90 degrees.
To check and adjust these positive stops, proceed as follows:
1. Raise the saw blade to its maximum height.
2. Set the blade at 90 degrees to the table by turning
the blade tilting handwheel counterclockwise as far
as it will go.
3. Place a square on the table and check to see if the
blade is at a perfect 90 degree angle to the table.
4. If the blade is not at 90 degrees loosen lock nut (C)
and turn stop ring (D) in or out. The stop ring (D)
should stop against the front trunnion bracket when
the blade is at 90 degrees to the table. Recheck and
adjust further if necessary. Retighten lock nut (C).
5. If the 45 degree positive stop is not set properly, turn the same handwheel clockwise as far
as it will go and follow the same procedure using lock nut (A) and stop ring (B). The stop bolt
(B) should stop against the front trunnion bracket when the blade is at 45 degrees to the
table. Recheck and adjust further if necessary. Retighten lock nut (A).