B9Creations Core Series Printer User Manual Rev. A-3
04-14-2020
energy and, if not installed and used in accordance with the User Manual, may cause harmful interference
to radio communications. However, there is no guarantee that the interference will not occur in an
individual installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that of the receiver.
Consult the dealer or an experienced radio/TV technician for help.
If this equipment is receiving interference that affects the
B9Creations Core Series
, the user is encouraged
to try to correct the interference by one or more of the following measures:
Reorient or relocate the printer or emitting equipment.
Increase the separation between the printer and emitting equipment.
Connect the printer into an outlet on a circuit different from that of the emitting equipment.
Isolate the printer and emitting equipment from each other, setting up in separate rooms if
possible.
3
Intended Use and Proper Operation
3.1
Intended Use
The
B9Creations Core Series
printer utilizes light to create 3-d objects in a Photoinitiated liquid used in
jewelry, model-making, art, prototyping and research.
The unit is not suitable nor intended for any purpose other than printing in these stated industries or
recreations.
3.2
Proper Operation
CAUTION
The unit is suitable to be set up and operated clean environments. The unit has been designed for
continuous operation.
Only clean, approved material (“Resin”) specifically designed for the
B9Creations Core Series
shall
be used. Use of third party or unapproved material will void the warranty of the DuraVat.
Remove the printed item and cured resin from the printer when printing is completed.
Do not attempt to remove printed item from Build Table while Build Table remains installed in the
printer.
Read and follow safety instructions of every liquid material in use. Wear personal protective items
if requested and strictly follow instructions for handling, storage and disposal of material.
Printing material must be kept from exposure of ambient light (e.g. tungsten light, direct sunlight)
while not being used for printing. Printing material shall be stored in suitable storage containers
that do not allow exposure to ambient light.
It is mandatory to close the front door before starting the print. The unit operates only when the
front door is completely closed.
NOTE
Do not install additional software if not authorized by B9Creations, LLC .
