B9Creations Core Series Printer User Manual Rev. A-3
04-14-2020
Turn off the rear On/Off switch
Unplug the mains connecting cable
Clean the print chamber (see section
10.1.1
)
Place the DuraVat cover on the DuraVat or completely clean the DuraVat free of material
Close the front door of the printer
7.5
“Function Button” Functions and Corresponding LED Ring Illumination Codes
The Function Button:
Activates the touchscreen display from Stand-by Mode when pressed - Light turns solid On.
Returns printer into Stand-By Mode when pressed - Light ebbs On and Off in a slow cycle.
Pauses printing when pressed once while printer is printing - Light blinks On and Off.
Re-starts paused printing when pressed again - Light turns on for approximately 1 second, turns off
½ second, then repeats throughout duration of printing.
Indicates printer is printing - Light turns on for approximately 1 second, turns off ½ second, then
repeats throughout duration of printing.
Indicates printer is finished printing - Light blinks ½ second On, ½ second Off, repeat.
Indicates door open during printing - Light blinks ¼ second On, ¼ second Off, repeat.
NOTE
The Function Button will not reboot the printer.
7.6
Setup Troubleshooting
If an error is encountered, follow each “Possible Causes” and “Remedy” in order of listing in the table.
Error description
Probable Causes
Remedy
1
The printer does not
turn on after
pressing the
Function button.
Printer has not completed
booting up
Check Function button to see if
it is blinking. If it is slowly
blinking, printer is booting up.
Wait for printer to complete
boot cycle.
Printer requires a re-boot
(toggle switch on back of
printer)
Turn rear On/Off button “Off.”
Wait 15 seconds. Turn rear
On/Off button “On.”
Main connecting cable
disconnected from mains or
printer.
Connect the main cable to
mains and printer
Rear On/Off switched Off
Turn On the rear On/Off switch
No power to mains outlet
Inspect mains electrical fuses or
breaker switch
Defective power supply
Confirm LED lit in power supply
