SmartSwarm 300 Series
:
126
In the screenshots shown here we have enabled the ALB002 Agent for debug purposes.
You can use the ALB002 Agent to verify that your Serial Interface is configured correctly. If you enable Debug on
Agent ALB002, and your serial interface settings are correct, you should see data streaming for ALB002 on the
Agents Tab.
The default setting for debugging each of the Agents is ‘disabled’. We recommend you leave these settings
disabled (not checked), before and after your Troubleshooting session. This is because the more debugging you
enable, the more the performance of your device will degrade.
We recommend that you only use the Debug interface, if necessary, in collaboration with the Advantech B+B
SmartWorx technical support personnel.
15.1.9 TSED
The Time Series Event Detection Agent is treated differently than the other Application Agents.
This is the agent that will detect when complex trigger-events occur: i.e. when the data-pattern detected matches
a defined Event Rule.
You cannot turn this Agent debug stream on or off.
When there are “complex” Events causing Triggers, the TSED agent will always be available. It will stream output
to the Web Server’s “Agents” tab.
The following Events are Complex Events: Delta; High Threshold; Low Threshold; High Rate; Low Rate.
