B & G H3000 Pilot, Руководство пользователя

Страница: 41 / 128

___________________________________________________H3000 Pilot Handbook
HB-3001-02 41
USE SOG AS SPEED INPUT
This sets the speed source used by the instrument system.
Choose between Boat Speed and SOG (Speed Over Ground) as your
speed input. The default setting takes speed input from the paddle wheel
sensor. If you choose to use SOG instead of boat speed this will take data
from your GPS input. This can be used in the event of damage/fouling of
the paddle wheel sensor and/or on very high-speed vessels where the
sensor has limited contact with the water.
Note: If SOG is selected the Pilot will also be using SOG even if set to
use boat speed. If you wish to use SOG only on the Pilot refer to page 65.
Example 1: Use SOG as speed input
COMMISSION
X
USE SOG AS BOATSPEED
X
ON/OFF
TS
↵
HEADING
This setting controls the source of heading data used by the instrument
and Pilot system.
Select the heading source:
Device Node
CPU (NMEA input)
5
Halcyon Processor (“Halcyon Gyro” input)
15
Halcyon Processor (NMEA input)
15
Halcyon 2000 Compass
16
ACP Pilot (direct “Halcyon Gyro” input)
18
NMEA Input to NMEA FFD
96, 97…
Heading Source
Example 1: Set the heading source to use a Halcyon Gyro-Stabilised
Compass connected directly to the PILOT ACP
COMMISSION
X
HEADING
X
Select Source (18)
TS
↵