B & G H3000 Pilot, Руководство пользователя

Страница: 91 / 128

___________________________________________________H3000 Pilot Handbook
HB-3001-02 91
Pilot computer unit
Boatspeed
Terminals
Function
Cable
135-0B-098
Green Speed Signal Input Red Wire
Red Not Used Not Used
Black Ground Blue Wire
Silver Screen Screen
Non-B&G Paddle Connection
ROTARY RUDDER REFERENCE SENSOR
Installation of RRF
A number of key points must be considered for optimum performance of
the unit:
Mount the unit on a flat surface next to the tiller arm or steering quadrant.
Construct a small platform if necessary.
Do not lengthen the drag-link arm as this can transmit excessive vibration
to the sensor.
The sensor operating arm can be rotated through 360º. The mid-point of
the RRF wiper travel is when the arm is opposite the cable entry point.
The sensor arm should be approximately opposite the cable entry point
when the helm is in the mid-ships position.
When the rudder is moved hard-over port or hard-over starboard, the RRF
arm should travel through a minimum angle of 90º to ensure sufficient
voltage swing. Measure the voltage difference between the blue (0V) and
green (signal) wires from the RRF; there should be at least a 1V dc change
from port to starboard.
After fitting and connection of the RRF test the full movement of the
steering gear to ensure no fouling occurs between the ram drive, steering
gear and RRF.
Check for backlash in the linkages. Excessive backlash will cause errors
in the operation of the Pilot.