AB-6569
2
Safety Precautions
Please read instructions carefully and use the product as specified in this manual. Be sure to keep this manual nearby for quick
reference.
Restrictions on Use
This product was developed, designed, and manufactured for general air conditioning use.
Do not use the product in a situation where human life may be at risk or for nuclear applications in radiation controlled areas.
If you wish to use the product in a radiation controlled area, please contact Azbil Corporation.
Particularly when the product is used in the following applications where safety is required, implementation of fail-safe design,
redundant design, regular maintenance, etc., should be considered in order to use the product safely and reliably.
•
Safety devices for protecting the human body
•
Start/stop control devices for transportation machines
•
Aeronautical/aerospace machines
For system design, application design, instructions for use, or product applications, please contact Azbil Corporation.
Azbil Corporation bears no responsibility for any result, or lack of result, deriving from the customer's use of the product.
Warnings and Cautions
WARNING
Alerts users that improper handling may cause death or serious injury.
CAUTION
Alerts users that improper handling may cause minor injury or material loss.
Signs
Alerts users to possible hazardous conditions caused by erroneous operation or erroneous use. The symbol inside
indicates the specific type of danger. (For example, the sign on the left warns of the risk of electric shock.)
Notifies users that specific actions are prohibited to prevent possible danger. The symbol inside
graphically
indicates the prohibited action. (For example, the sign on the left means that disassembly is prohibited.)
Instructs users to carry out a specific obligatory action to prevent possible danger. The symbol inside
●
graphically
indicates the actual action to be carried out. (For example, the sign on the left indicates general instructions.)
WARNING
DANGER: To prevent the risk of severe or fatal electrical shock, always disconnect power source and product
power supply before performing any wiring.
Do not disassemble the product. Disassembly may result in electrical shock or equipment damage.
Make sure all the wires are tightly connected. Loose connection can cause burn injury due to heat generation or
fire.
Be sure to ground with 100
or lower ground resistance. Improper ground can cause electrical shock or product
fault.
Wire strip length to be connected to the quick-fit screwless terminal block must be 5 mm to 6 mm. If the strip length
is longer than 5 to 6 mm, the conductor will be exposed, causing electrical shock or short circuit between adjacent
terminals. If it is shorter, the conductor will not contact the connector.
CAUTION (1/2)
Installation and wiring must be performed by qualified personnel in accordance with all applicable safety
standards.
All wiring must comply with local codes of indoor wiring and electric installation rules.
Use crimp terminal lugs with insulation for electric wires connected to the screw terminals.
Connect cables to the power source with terminals lugs or the like for permanent connection.
