6
USER MANUAL
ENGLISH |
This device is a lighting effect for professional use on stages,
in discotheques, theatres, etc.
This fixture is only allowed to be operated with the max
alternating current which stated in the technical specifications
in the last page of this manual, the device was designed for
indoor and outdoor use.
Installation instructions
CAUTION !
Please consider the GB7000.15/EN60598-2-17
and the other respective national norms during
the installation. The installation must only be
carried out by a qualified person.
The applicable temperature for the projector is between
-20°C to 45°C. Do not use the projector under or above the
temperature.
The installation of the effect has to be built and constructed in
a way that it can hold 10 times the weight for 1 hour without
any harming deformation.
The installation must always be secured with a secondary
safety attachment, e.g. an appropriate safety rope.
Never stand directly below the device when mounting,
removing or servicing the fixture.
The operator has to make sure the safety relating and
machine technical installations are approved by an expert
before taking the device into operation for the first time.
These installations have to be approved by a skilled person
once a year.
CAUTION !
Before taking into operation for the first time, the
installation has to be approved by an expert.
Cautions :
The effect should be installed outside areas where persons
may reach it, walk by or be seated.
Overhead mounting requires extensive experience, including
amongst others calculating working load limits, installation
material being used, and periodic safety inspection of
all installation material and the device. If you lack these
qualifications, do not attempt the installation yourself.
Improper installation can result in bodily injury.
CAUTION !
The electric connection must only be carried
out by a qualified electrician.
Before mounting make sure that the installation area can hold
a minimum point load of 10 times the device’s weight.
Connect the fixture to the mains with the power plug.
Installation method via clamp
Please refer to the picture below:
Fix the clamp on the bracket by tighten up the M12 screw on
the bracket to the 13mm hole in the middle of the bracket.
Pass the safety rope through the connecting hole under the
side panel, hanging on the fixed bracket or other fixed station,
and can also be floor-mounted(or on any other flat surface)
without fixing, remaining steady no matter what the angle of
the head. Fully operational in any mounting position, hanging
upside-down, side mounted, or set on a flat level surface,
etc. When clamp mounting; always use and install the
supplied safety cable as an added safety measure to prevent
accidental damage in the event of a clamp failure. Be sure
this fixture is kept at least 0.1m away from any flammable
materials (decoration etc.).
DMX-512 control connection
Connect the provided XLR cable to the female 5-pin XLR
output of your controller and the other side to the male 5-pin
XLR input of the moving head. You can chain multiple
Moving head together through serial linking. The cable
needed should be two core, screened cable with XLR input
and output connectors. Please refer to the following diagram:
INST
ALLA
TION INSTRUCTIONS