AVProEdge AC-MX-88, Руководство пользователя

Страница: 36 / 51

36
Display IP Information:
In order to see the current IP settings, press and hold (for 3 seconds) INPUT 3 and INPUT 4 buttons
simultaneously. This screen will change every 3 seconds showing additional settings (host, net mask,
router IP).
NOTE: This screen always starts with the current IP address of the matrix:
In order to toggle DHCP on and off, press and hold (for 3 seconds) the INPUT 1 and INPUT 4 buttons
simultaneously.
In order to prevent potential IP problems, you can change the IP settings by using RS-232 com-
mands (connect via the Micro USB port or 3 Pin Terminal RS-232 connection).
NOTE: The default IP address is 192.168.001.239 (as pictured above).
Quick Network Connect to Web Interface:
Use the following steps to quickly and immediately connect to the matrix switch:
1. Connect the LAN port into an active router port.
2. On most networks you can simply type the Default IP address into any web browser. The De-
fault IP Address is 192.168.1.239
If you are on a closed network or non-standard, the following may work better when using DHCP:
1. Use an Ethernet cable to connect the LAN port on the switch to an unused, active port on the
router.
2. Enable DHCP by pressing the INPUT 1 and INPUT 4 buttons simultaneously for 3 seconds.
3. Wait 5 seconds, then press and hold (for 3 seconds) the INPUT 3 and INPUT 4 buttons simul-
taneously. The display will show the assigned IP address.
4. Input the IP Address into any web browser.
Setting a Static IP:
·
Once connected, you can use the web interface to set a static IP address.
·
A static IP can also be set by using the RS-232 software or a direct command (see Command
list for more information).