AVL Looms A Series, Инструкция по сборке

Страница: 84 / 176

Installing Beams And Rollers A-Series Dobby Loom Assembly Manual
Page | 76 Cloth Storage System
5) Find the Cloth Storage Drum Assembly (#29). There is a cloth
storage drum with roller tube end and shaft attached to it. It will be
mounted to the bottom of the right rear vertical on the outside of
the loom.
6) Loosen the set screw inside the tube end and remove it with one
washer from the shaft.
Figure 79 - Cloth Storage Drum
7) Insert the shaft through the rear vertical from the outside.
8) Replace the washer and the tube end. Tighten the set screw.
9) Route the cord from the cloth storage drum around the pulleys as
shown in the photo.
a. From the storage drum, route the cord up the rear vertical.
b. When the end of the cord is between the two pulleys that are
side-by-side on the upper horizontal, insert the cord through
the metal counter weight pulley and continue routing over the
last pulley on the upper horizontal.
Note:
While you are setting up the loom, leave enough cord so that the cloth
storage weight is on the floor. You can also lock the weight in place by
putting the retention pin through the cloth storage drum and the rear vertical.
c. Route the cord all the way down to the pulley on the lower
horizontal.