AVL Looms A Series, Инструкция по сборке, Страница: 120 / 176

Overhead Beater (Optional) A-Series Dobby Loom Assembly Manual
Page | 112 Two-Box Flyshuttle – Dropbox Movement
4) After the cord has gone through the picker, add the small spring,
then the washer from the hardware packet to the cord
Figure 114 - Spring and washer on Flyshuttle cord
5) Tie a knot in the cord.
Note:
The positioning of this knot will determine the operating height of the flystring
handle, so make sure that you are satisfied with its position before tying the
knot. If there is more than an inch or so of cord left beyond the knot, you may
want to snip off the excess cord.
6) Repeat these steps for the other side of the loom.
T
WO
-B
OX
F
LYSHUTTLE
– D
ROPBOX
M
OVEMENT
Attach the shift handle
The shift handle allows you to switch between boxes.
1) On each side there is a cable attached to the drop box which has an
eyebolt on the end. This cable is routed over the top of the drop
box pulley and the eyebolt threads into the turnbuckle on the end
of the cable coming from the shift handle.
Adjust the movement of the dropboxes
Note:
You can adjust the movement of the boxes both with the adjustment screw
and with the turnbuckle on the shift handle cables. Adjust each as needed
until the boxes are in the correct position.