AVL Looms A Series, Инструкция по сборке

Страница: 52 / 176

Install the Inner Workings A-Series Dobby Loom Assembly Manual
Page | 44 Treadle Tie-Up
10) Take the turnbuckle completely off the dobby cable and then restart
it again with no more than two turns.
11) Pull up the cable that makes the treadle go up and down and screw
the turnbuckle to the eyebolt (this is a reverse thread so turn the
turnbuckle in the same direction you did to start it onto the dobby
cable eyebolt).
Note:
The purpose of the turnbuckle is to give a way to adjust treadle travel so that
you get a full shed.
12) In order to get the proper adjustment, you’ll need to tighten or
loosen the turnbuckle until, when the left treadle is pushed all the
way down, the slide plate raises and touches the upper bumpers in
the dobby box.
13) At this point, the short treadle should stop about 1/2" to 1" below
its cable pulley. When adjusted properly, the right treadle should
stop approximately 1" to 2" from the floor on its down swing and
1/2" to 1" from the cable pulley on its upswing.