Avitech Titan 9000 series, Руководство пользователя

Страница: 169 / 172

163
H.3 Cropping Feature
ScreenCropT utility sets 2 instances of “area of interest.” The associate contents can then be
transmitted to the intended audiences. To crop areas of interest, perform the following steps.
Figure H-3 Cropping a Defined Area of Interest
Step 1. Click to select the detected Titan 9000 multiviewer in the “Devices on Network” window. In the
case of cascaded setup, it is highly recommended to set all the Titan 9000 to the same IP
address, but set with different rotary ID setting, and then using the “Chassis ID” drop-down
menu to select.
Step 2. Click to select the “Chassis ID” (in the case of cascaded setup and that the Titan 9000 are set to
the same IP address), “Card ID,” and “Image ID” to perform cropping.
Step 3. Click the Crop button and use the cursor to select an area to crop. Upon releasing the left
mouse button, 4 green cropping corners will display the selected area.
9
A floating 5× magnifying window will display any nearby graphics at 5x and other
relevant cursor information (e.g., position and RGB value).
Figure H-4 Magnified Floating Window Showing Cursor and RGB Value
9
Click and drag any of the 4 green cropping corners to enlarge/reduce the area just
selected. You may also use the keyboard’s top/left/right/down buttons to fine-tune the
scope of the area to be cropped instead of using the mouse button.
9
For additional fine tuning, you may manually enter the values of the Left/Top/Width/
Height and click the Set button. This will modify the scope of area to be cropped at
pixel-level accuracy.