8
AN-16/
i
v
.2 i
Nput
M
odule
u
ser
G
uide
Installing in an Equipment Rack
The AN-16/i v.2 Input Module is designed to be installed in a standard 19-inch audio equipment rack. This
design is both for easy transportation of the unit and for protection. Each unit takes up one standard rack
space (19 inches wide by 1.75 inches high).
The rack ears on each side of the device are designed to support the weight of the AN-16/i v.2 without
additional hardware. Each rack ear contains holes for two screws per side. Always support the unit with all
four screws.
To rack mount the AN-16/i v.2, position it in the equipment rack at the desired location. Use standard rack-
mounting screws (10-32 size) to attach the unit to your rack hardware. Tighten all four screws firmly, but
avoid overtightening.
You may want to use non-metallic washers between the rack-mounting screws and the device’s finished
surface to avoid marring the painted finish on your Aviom products.
Always allow adequate ventilation for devices mounted in equipment racks. Avoid placing your Pro16
product directly above or below other rack-mounted devices that produce high levels of heat, such as
power amps.
Cleaning and Maintenance Information
The exterior of your Aviom products should be cleaned with a dry, soft, lint-free cloth. For tougher dirt,
you can use a cloth slightly dampened with water or with a mild detergent.
When cleaning your Aviom products, never spray cleaners directly onto the product surfaces. Instead,
spray a small amount of the cleaning solution onto a clean cloth first. Then use the dampened cloth to
clean the product.
P
N
ote
:
Never use solvents or abrasive cleaners on the finished surfaces of your Aviom products.
