17
Rudder Control Horn Setup
Use three, 3x4mm self-tapping
screws to secure the tail wheel
bracket to the holes drilled in the
last step.
Using two 8-32x3/4” allen bolts,
run them through the gear and
through the holes in the pant.
Take a small square piece of
plywood and glue it to the inside
of the pant. Now take two 8-32
blind nuts and tighten the allen
bolts. Once the blind nuts are
tight add a small amount of glue
to the blind nuts to hold them in
place. Glue another piece of ply
to the opposite side of the pant to
catch the axel. This will provide
some additional strength.
Mount the rudder control horn to the
rudder the same way as the elevators
and ailerons. Make sure that with full
up elevator you have plenty of clear-
ance between the control horn and
the elevator. If you do not have the
proper clearance the elevator will hit
your pull-pull wire. Once your control
horn is mounted you can now install
the pull-pull wire. Make sure that the
wire goes straight to the rudder servo
in the fuse.
