13
Install horizontal stabilizer
Use a sharp hobby knife
to carefully trim the
covering around the
holes in the fuse for the
stab tube and the bolt
holes on each side. Slide
t h e a l u m i n u m
tube(supplied) through the fuse, and slide the stabi-
lizers onto the tubes from each side. Make sure that both stabs are snug against
fuse. Using the 6-32 allen bolts(supplied), attach the stabs to the fuse.
Install the Control Horns
Elevator Servo Installation
Mount the provided control horns to each
control surface on the hard points. Try and
get the control horn base as close to the
leading edge of the control surface. This will
provide the proper geometry and allow the
control surface to move both directions
equally. For the elevators, place each horn
1” from the fuse, and the exact same dis-
tance from the hinge line. Otherwise, the
geometry will be different and it will be diffi-
cult to adjust the throw amount to be equal
in both directions. (See diagrams below)
Stab
Elevator
