Autostart AS-6650TW-FM, Руководство пользователя

Страница: 18 / 18

P. 18
User Guide
Diagnostics – Parking Light Flash Table
Flashes Description
1
• Doors locked, Alarm and starter kill armed.
•
Run time has expired.
•
TRUNK
button pressed.
•
Start signal received by the module.
• Cold weather mode cancelled.
2
•
Remote start attempt cancelled by remote.
• Doors unlocked, starter kill disarmed.
• Exiting ignition valet
•
Power ON to OFF(Automatic transmission)
•
Exiting remote valet
•
Power-up reset.
•
Board set from manual to automatic; power
ON
2 slow flashes then
8 quick flashes
• Reset from Manual to Automatic
3
•
Entering cold weather mode
•
Entering ignition valet
•
Entering or exiting Ready Mode
• Entering remote valet.
•
Entering extended run time.
4
•
+12 V detected on the brake input wire
either while cranking or during run time.
• Entering multi-speed tach programming.
•
Board set from automatic to manual; power
ON
• Power ON to OFF ( manual transmission)
5 Fast
•
Tach signal programmed.
•
New transmitter programmed.
6
•
A remote start was attempted while a tach-before-crank signal was detected before cranking.
8 •
Unit reset
10 •
A ground (-) signal was detected on the hood pin input wire.
When pressing
START/STOP
15 quick flashes
• The parking brake is connected to ground (automatic transmission)
1 – pause – 2
•
There was a remote start attempt while the vehicle was in valet mode.
•
Failed start: vehicle’s low battery voltage.
…followed by 1 flash
•
Entering cold weather mode ON SOLID for 3
seconds….
…followed by 3 flashes • Entering cold weather mode
ON continuously • Idle mode: Idle mode is engaged
•
Run time: The vehicle has been remote started and is in run time.
ON 2 seconds
•
The hood has been opened and a ground (-) signal has been detected on the hood pin input
wire.
ON 4 seconds
•
Locking or unlocking a door (with Door pulses configured to 4 sec.)
ON 20 seconds •
The hood pin has been flashed and you now have access to the programming options.
Constant flashes
up to 60 sec.
•
In Siren or Horn Mode: Alarm condition generated by an intrusion, by Panic Mode or when the
System is powered up.