User Guide
P. 5
3.
Within 20 sec. push
LOCK
,
UNLOCK
or
START/STOP
on the transmitter.
The parking lights will flash 3 times quickly and remain lit.
4.
Remove the key: the engine will go on running.
5.
Exit the vehicle and close the door.
6.
Press the
TRUNK
button until the system is armed (the doors will be locked if remote door lock
is installed).
If the pre-programmed run-time expires or if the user shuts down the engine by remote control, the
vehicle will get in ready mode.
Caution!!!
Do not leave children or pets unattended in a vehicle standing in idle mode.
Turbo Mode
If Turbo Mode is configured at installation, it will allow a turbocharger to idle down after the user
leaves the vehicle: the unit will take over the vehicle and keep it running for 60 seconds (or until it
is shut down by remote control), then shut down the engine and set the Remote Car Starter to
Ready Mode.
If your vehicle has an automatic transmission, proceed as follows to set the system in
Turbo Mode
:
1. With the engine already running, press the
LOCK
button on the transmitter until the parking
lights come
ON
.
2.
Remove the ignition key from the ignition switch.
The engine will go on running.
3.
Exit the vehicle and close the door.
4.
Press the
TRUNK
button to lock the doors; the engine will shut down after
60 seconds of Turbo Mode.
If your vehicle has a manual transmission, follow all steps of the Ready Mode routine, to
activate Turbo Mode:
1.
Ensure that all the doors are closed and that the shifter is in the neutral position.
2.
With the engine already running, apply the parking brake and release the brake pedal.
Make sure to release the brake pedal.
3.
Within 20 sec. Press
LOCK
,
UNLOCK
or
START/STOP
on the transmitter.
The parking lights will flash 3 times quickly and remain lit.
4.
Remove the key: the engine will go on running.
5.
Exit the vehicle and close the door.
6.
Press and hold either:
a.
LOCK
to lock the doors and shut down the engine after 60 sec.;
b.
UNLOCK
to unlock the doors and shut down the engine after 60 sec.;
c.
START/STOP
to shut down the engine immediately, without affecting the doors
(this will by-pass Turbo Mode).
d.
TRUNK
to set the vehicle into idle mode
Valet Mode with the Valet Switch
When your vehicle is in valet mode, the remote starter functionalities are disabled. If the vehicle
needs to be serviced, or if you park it indoors, the valet mode will prevent the engine from being
remote-started accidentally.
To put the system i n t o valet mode:
1.
Turn the ignition key to the
IGNITION ON (RUN)
position.
2.
Within 3 seconds, press the valet button. The parking lights will flash three times and the L.E.D.
will turn itself on.
— The
icon will appear on your LCD remote.
To take the system o u t o f valet mode:
1.
Turn the ignition key to the
IGNITION ON (RUN)
position.
