User Guide
P. 3
Windshield Wipers, Radio & Headlights
Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to become
energized while running under remote start. When leaving the vehicle you must ensure that the
windshield wiper and headlight switches are
OFF
. Leaving the headlight switch
ON
on certain types
of vehicles could cause them to remain
ON
even after remote starter shut down, resulting in a dead
battery.
Remote-Starting Your Vehicle
If your vehicle has an
automatic transmission
, simply press the
START/STOP
button to remote start
your vehicle. Skip the next steps on to “Remote-starting”.
Warning:
If you vehicle has an automatic transmission and the parking lights flash 15 times after
pressing the button, please see your installer as programming will have to be modified.
Setting Your Vehicle Into Ready Mode
If your vehicle has a
manual transmission
you must read the following indications. In order to
start the vehicle by remote, the unit must first be set to Ready Mode. If the unit is not set to Ready
Mode, it cannot remote start the vehicle.
Please note that Ready Mode can be enabled by the remote or the handbrake, depending on
the option that was selected by your installer. Therefore, you must follow the appropriate
procedure between the two described below in order to set your vehicle into Ready Mode.
Once the system is set to Ready Mode, the vehicle can be remote started and stopped at any time.
The system will exit Ready Mode if a door, the hood or the trunk is opened, if the brake pedal is
pressed, if the parking brake is disengaged or if the ignition key is turned to the
IGNITION ON (RUN)
position.
To set the system to Ready Mode:
If Ready Mode is enabled by remote
If Ready Mode is enabled by handbrake
1.
Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector is in the
neutral position.
2.
With the engine already running, apply the
parking brake
once
and release the brake
pedal.
Make sure to release the brake pedal.
2.
With the engine already running, apply the
parking brake
twice
and release the brake
pedal.
Make sure to release the brake pedal.
The parking lights will flash 3 times
quickly and remain lit.
Skip to step 4.
3.
Within 20 sec. of engaging the parking
brake, press and hold
LOCK
,
UNLOCK
or
START/STOP
on the transmitter.
The parking lights will flash 3 times
quickly and remain lit.
-
4.
Remove the key: the engine will continue running.
5.
Exit the vehicle and close all doors, hood and trunk.
6.
Press for approx. 1 second either:
a.
LOCK
to lock the doors and shut down the engine;
b.
UNLOCK
to unlock the doors and shut down the engine;
c.
START/STOP
to shut down the engine without affecting the doors.
7.
The icon will appear on your screen.
Remote-starting
Press the
START/STOP
button for approx. 1 second. The parking lights will come
ON
and the remote
control will play a melody to inform you that the system has received your signal. Approximately 5
