P. 10
User
Guide
Ignition Re-lock
On systems of this series, when ignition-controlled door locks
are enabled and the ignition key is in
the
IGNITION ON (RUN)
position, should any door be unlocked and opened, all doors will be relocked
next time the brake pedal is pressed.
Relock
If you unlock the doors with the remote transmitter, but do not open any doors, hood or trunk, or
turn ignition within 30 seconds, the doors will automatically relock and rearm the system.
Note:
When the system is in
active arming
mode and the
relock
mode is enabled, the doors
will relock but the system will not rearm.
Secure Lock
Before it can remote-start your vehicle, the system must first disarm the factory security system.
The secure lock feature may be required on certain vehicle models with factory security systems
that automatically unlock the doors when the security system is disarmed. To keep your vehicle
protected when the factory security system is disarmed for a remote start, secure lock will relock
your doors as soon as the vehicle has started. Once the engine run cycle ends, secure lock will
rearm your factory security system.
Turbo Mode
When left in turbo mode, the system will keep the engine running for 60 seconds before shutting it
down. This is to allow a turbocharger to idle down after the user leaves the vehicle.
See turbo
mode section earlier in this guide.
Remote Trunk Release
If your system was installed with the remote trunk release option, you can open your trunk by
pressing the
TRUNK
button for 3 seconds on the remote transmitter or by pressing the
TRUNK
button
twice within 3 seconds.
Note:
When pressing the
TRUNK
button, the
TRUNK
will open and the security system will disarm. If
your vehicle is in passive mode, the system will rearm after a 30-sec. Delay, once the trunk is
closed. If your vehicle is in ready mode, it will be cancelled as soon as the trunk opens.
Engine Run Time
(15/20 minutes by default.) If you have a gas engine, your System can be programmed to run the
engine for 3, 15, or 25 minutes (15 minutes by default). If you have a diesel engine, the System
can be programmed to run the engine for 8, 20, or 30 minutes (20 minutes default).
Extended Run Time
While the vehicle is running under a remote start,
pressing and holding the button for more
than 3 seconds
will reset the run time counter to zero and restart the run time cycle from the
beginning. There will be three beeps and the parking lights will flash three times.
The extended
run time procedure can only be carried out once per remote start.
To stop the vehicle, at any moment, simply press the button.
Example:
If your remote car starter is programmed for a run time of 3 minutes and your vehicle
has been running for 2 minutes already, pressing the button will reset the counter to zero and
allow the engine to run for another cycle (in this case, 3 minutes).
Separate Start and Stop buttons
The Auxiliary button [
] can be programmed as the Stop button – Mode 4, Function 3, Option 1
Temperature Request (If ACC-Temp-101 installed)
The user can request the temperature in the vehicle if a Temperature Sensor Module (ACC-Temp-
101) is installed:
