User Guide
P. 17
Diagnostics – Chirps Table
Chirps
Description
1
•
Doors locked, alarm and starter kill armed.
•
LOCK
confirmation.
•
Entering mode 1 in the programming centre.
•
Disarmed notification
2
•
Doors unlocked, alarm and starter kill disarmed.
•
Transmitter programmed.
•
Entering mode 2 in the programming centre.
3
•
LOCK
and arm while a zone is left unprotected.
•
Entering mode 3 in the programming centre.
•
Door zone left unprotected.
4
•
UNLOCK
and disarm: an intrusion was detected (in warning chirps mode or full chirps
mode).
•
Entering tach-programming mode.
•
Entering mode 4 in the programming centre.
5
•
Siren or horn chirp timing adjustment
Constant up to
60 seconds
•
In siren or horn mode: alarm condition generated by an intrusion, by panic mode or
when the system is powered up. The siren or horn will sound for 60 sec.
Diagnostics – Parking Light Flash Table
Flashes
Description
1
•
Doors locked, Alarm and Starter Kill armed.
•
End of Run Time.
•
TRUNK
button pressed
•
Start signal received by the System.
•
Cold Weather Mode cancelled.
2
•
Doors unlocked, alarm and starter Kill disarmed.
•
Run time cancelled.
•
Exit remote valet.
•
Exit ignition valet
•
Remote start attempt cancelled by remote.
3
•
Entering cold weather mode.
•
Entering remote valet.
•
Entering ignition valet
4
•
+12 V where detected on the brake line and cranking was cancelled.
•
Entering tach-programming mode
5
•
New transmitter programmed.
•
Tach programmed.
6
•
A remote start was attempted while a tach or a vacuum signal was detected before
cranking.
8
•
Unit reset: occurs when the unit is reset to the factory defaults.
10
•
The hood switch line went to ground during cranking or run time.
1 – pause – 2
•
There was an attempt to start the vehicle while the system was in valet mode.
2 – pause – 2
•
There was an attempt to start the vehicle while the system was in home valet mode.
ON solid
•
Cold weather mode: the Brake Pedal is being held down.
ON 2 sec.
•
The Hood is up and the Hood Switch line went to ground. This is step one of the
Programming Centre procedure.
ON 3 sec.
•
First press of the
START/STOP
button under Safe Start.
ON 4 sec.
•
Locking or unlocking a door (with Door pulses configured to 4 sec.)
ON 25 sec.
•
The hood pin-switch has been pressed twice: the unit went into step 1 of the
programming centre procedure, and no transmitter activity was detected for 20
seconds.
•
Or
the unit went into step 1 of the transmitter programming procedure and no activity
was detected for a few seconds. The unit has exited the transmitter programming
procedure.
