P. 3
User Guide
With many advanced functions, this product will satisfy any one your expectations from high-end
commodity and security systems, without neglecting any standard feature commonly offered by
entry-level starters.
Remote-Starting Your Vehicle
Remote-starting
Press the
START/STOP
button for approx. 1 second. The parking lights will come
ON
and the remote
control will play a melody to inform you that the System has received your signal. Approximately 5
seconds later, the engine will start. The parking lights will remain
ON
during the pre-programmed
run time of the engine.
If the vehicle does not start at the first attempt, the system will shut down, wait a few seconds and
try to start the engine again. There will be 3 start attempts before the system gives up.
Vehicle Presets
Heater & Heated Seat
When leaving the vehicle it is recommended to preset the accessory controls in preparation for the
next remote start. Settings for the blower motor (fan), front and rear, as well as heated seats (if
equipped) should not be left on
HIGH
. It is recommended to leave the settings on
LOW
or
MEDIUM
instead.
Windshield Wipers & Radio & Headlights
Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to become
energized while running under remote start. When leaving the vehicle you must ensure that the
windshield wiper and headlight switches are
OFF
. Leaving the headlight switch
ON
on certain types
of vehicles could cause them to remain
ON
even after remote starter shut down, resulting in a dead
battery.
Driving Off
With the vehicle running under remote control, press the
UNLOCK
button to disarm and unlock the
doors. Enter the vehicle and do the following:
Turn the ignition key to the
IGNITION ON (RUN)
position. (
Do not turn the key
to the
CRANK
position
while the engine is running. This would cause the starter motor to re-engage.)
Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.
Basic Vehicle Operation
The vehicle can be remote-started and stopped using the
START/STOP
( ) button. The
TRUNK
( )
button will open the trunk (if this feature is installed on the vehicle). The
LOCK
(
) and
UNLOCK
( ) buttons will lock and unlock the doors of the vehicle (if the remote door lock feature is installed
on the vehicle) and arm or disarm the starter kill (if installed). The
FUNCTION
(
) button is used to
access all advanced functions of the remote control. The AUXILIARY button (
) is used to
activate AUX 2 or to Stop the engine (if programmed as the Stop button). (Refer to the LCD
Transmitter Operation tables.)
Alarm Clock
The LCD remote control has a built-in alarm clock that can be set up using the
button.
Use the
and buttons to switch the alarm clock on and off (refer to the tables).
