P. 7
User Guide
Getting o u t of Remote Valet Mode
•
Hold the
UNLOCK
and
START/STOP
buttons simultaneously for 3 seconds.
•
The Parking Lights will flash 2 times.
The Transmitter will BEEP once and the
icon will disappear; the LED will turn off.
Note
:
With the Remote Valet activated, the remote starter function will be disabled.
Panic Mode
In an emergency situation, you can activate Panic Mode using the
LOCK
or
UNLOCK
button. This will:
•
shut down the engine,
•
unlock the doors (with the
UNLOCK
button)
•
or lock the doors (with the
LOCK
button),
•
disarm the Starter Kill and
•
activate the siren for 1 minute.
Note:
See the description of the
starter kill
option later in this guide.
To activate panic mode:
Press and hold the
UNLOCK
button for approximately 3 sec. until the sound signal starts
and the parking lights flash: this will unlock the doors before the sound signal starts.
Or
press and hold the
LOCK
button for approximately 3 seconds until the sound signal
starts and the parking lights flash: this will lock the doors before the sound signal starts.
If the panic mode is triggered while the system is armed in Passive mode, the alarm will sound for
30 seconds. If the system is armed in Active mode, the alarm will sound for 1 minute.
Note
:
To stop Panic Mode before the end of its delay, press the
LOCK
or
UNLOCK
button until
the sound signal stops.
Quick Lockout
TM
(Also called
Secure Panic
.) For fast protection in emergency situations, the system will
LOCK
all
doors when you
press the brake pedal while you hear the sound signal
. (
Quick Lockout
is
only available when
panic mode
has been set off.)
Cold Weather Mode
When cold weather mode is active, the engine starts every 2 hours and runs for 4 minutes (or for 9
or 20 minutes with diesel engines). Cold weather mode automatically ends after 24 hours.
To enter cold weather mode:
Press and release the
FUNCTION
button until you hear a beep. Release the
FUNCTION
button,
will appear, then press and hold the
START/STOP
button for 3 seconds until the parking
lights flash three times.
The remote control will beep once and the
icon will appear on the display.
To exit cold weather mode, do any one of the following actions:
Open the hood.
Start the engine by remote.
Turn the ignition key to the
IGNITION ON (RUN)
position.
Press the
FUNCTION
button until you hear a beep. Release the
FUNCTION
button and
will
appear on the display. Then press the
START/STOP
button for 3 seconds (the parking lights will
flash once).
When the system exits cold weather mode, the remote control will beep once and the
icon will disappear from the display.
To verify whether the system is in cold weather mode:
Press and release the brake pedal:
If the vehicle is in cold weather mode, the parking lights will stay on while the pedal is
pressed.
