P. 9
User Guide
Note:
After a remote start,
although the shock sensor is disabled, all the other alarm-
triggering zones, such as the doors, the trunk or the hood, may still trigger an alarm.
Disarmed Notification
(Off by default.) This feature will notify the user when the vehicle was left disarmed: after the
engine is shut down (with the key removed) and all doors are closed, the siren will chirp once after
a 10-sec. notification delay to warn the user that the vehicle was left unprotected. The notification
can be avoided by pressing the
LOCK
or
UNLOCK
button on the transmitter.
The user will likewise be notified after the System is disarmed using the transmitter.
Siren or Horn Chirps
(
ON
by default.) The siren will chirp to confirm basic operations on the System:
By default, upon
locking
the doors the siren will give
one chirp
if no protection zone is active.
If a
zone is active
as the doors are being
locked
, the siren will give
three chirps
.
When the doors are being
unlocked
, the siren will give
two chirps
if no intrusion was detected.
If an
intrusion was detected
, as the doors are being
unlocked
the siren will give
four chirps
.
The system can alternatively be set to:
Warning Mode:
no chirp during lock/unlock…
unless a zone is active when locking, in which case there will be 3 chirp upon locking
or unless the alarm was triggered, in which case there will be 4 chirps when unlocking);
Open Zone Notification Mode:
3 warning chirps if a door is left open 10 sec. after arming.
No Chirp:
the siren will not chirp under any circumstance.
Car Finder
(Enabled by default.) When enabled, the Car Finder option will help you locate your vehicle by
generating a pulsating signal through the horn or the siren. To hear the signal, press
FUNCTION
then
LOCK
.
Siren or Horn Chirp Timing
The duration of the chirps can be adjusted at installation (from 5 to 200 ms).
Safe Start
(Disabled by default.) If this feature is enabled, the user must press the
START/STOP
button 2 times
within 3 seconds to remote-start the vehicle. This will eliminate accidental remote starts, e.g. when
children are playing with the transmitter.
If
Swap Start Mode
is selected, to remote-start your vehicle press
FUNCTION
followed by the
LOCK
button. The
AUX 2
output can be activated by pressing the
START/STOP
button.
Home Valet
TM
(Disabled by default.) If this feature is installed, the user will have the possibility to remotely set the
vehicle to a no-remote-start mode. See
Home Valet
section, earlier in this Guide, for full
instructions.
Ignition-controlled Door Locks
(Disabled by default.) This is an added security feature. If your Systems was installed with the
Ignition-Controlled Door Locks option, the doors will automatically be locked as soon as the ignition
key is turned to the
IGNITION ON (RUN)
position while the brakes are pressed. When the key is turned
to the
OFF
position, the doors will automatically be unlocked.
Ignition Re-lock
On Systems of this series, when Ignition-controlled Door Locks
are enabled and the ignition key is
in the
IGNITION ON (RUN)
position, should any door be unlocked and opened, all doors will be
relocked next time the brake pedal is pressed.
Relock
If you unlock the doors with the remote transmitter, but do not open any doors, hood or trunk, or
turn ignition within 30 seconds, the doors will automatically relock and rearm the system.
