User Guide
P. 4
Time Adjust Mode
Use Time Adjust Mode to set the current time on your remote control using the
button
(refer to the tables).
Countdown Timer
This feature allows set up of a countdown for a duration entered by the user in hours and
minutes using the
button (refer to the tables).
Parking Countdown
This version of the countdown feature is particularly useful for keeping track of parking
meter time: the user may quickly set up the countdown in slices of 10 or 30 minutes using
the
and buttons (refer to the tables).
Melody Selection
The remote control allows the user to select which melodies are to be used upon the
following events: remote starting of the vehicle, the alarm, ending of the countdown, and
entering Cold Weather Mode. Melodies for these various events can be selected using the
button (refer to the tables).
Vibration Mode
Use this feature to replace audible signals with a vibration signal. Use the
and buttons to
switch Vibration Mode “ON” and “OFF” (refer to the tables).
Power Saving Mode
When set to Power Saving Mode, the remote control will cease polling the remote starter module
on a regular basis for status information. This will extend battery life. Press the button. Then
use the
and
buttons to switch Power Saving Mode “ON” and “OFF” (refer to the tables).
Remote Control Finder
This function allows the user to locate the remote control when it has been accidentally dropped
near the vehicle. Pressing the valet button and holding it down for 5 seconds (or until the parking
lights flash five times) will cause the remote control to start beeping for one minute. The beeping
will stop by itself after one minute, or it can be switched off by pressing the
LOCK
(
) or the
UNLOCK
( ) button on the Remote Control.
Using the System
Arming and Disarming the System
To disarm the alarm and Starter Kill (if installed) and unlock the doors (if installed):
1.
Press and hold the
UNLOCK
button for approx. 1 sec.
You will hear
two chirps
if the Siren or Horn is so configured.
The icon will light up on the LCD display of the remote control. The parking lights will
flash twice
and the L.E.D. will go out to confirm that the doors have been unlocked and that the Starter
Kill (if installed) and the alarm are disarmed.
In Passive Mode, the System will rearm automatically 30 seconds after unlocking unless the key is
inserted in the ignition switch (see description of
Passive Mode
later in this Guide).
To arm the alarm and Starter Kill (if installed) and lock the doors (if installed):
1.
Press and hold the
LOCK
button for approx. 1 sec.
