Autopilot Pool Pilot Digital Nano, Инструкция для владельца и по установке

Страница: 22 / 56

Page - 16
6.4 Winterizing
CAUTION - Failure to heed the following may result in equipment damage.
l
Special measures are required in the event of freezing conditions. The Pool Pilot
®
may be damaged if
measures are not taken in advance of freezing conditions. Equipment damage due to freezing
conditions is NOT covered under the equipment warranty.
During brief freezing conditions, allow the filtration system to run continuously throughout the
freeze period. Circulating (moving) water will not freeze.
In areas where freezing conditions are prevalent and sustained, the equipment must be
winterized as follows:
6.4.a Control Unit and Manifold Assembly
Figure 10
l
Drain all water from the manifold assembly (cell and Tri-sensor), pump, filter, supply
and return lines prior to freezing weather.
l
If desired, AutoPilot
®
plug kit #996 may be purchased to cover the openings. The
manifold assembly, including the cell, Tri-sensor and cables may be stored indoors.
l
The control unit is not affected by the cold and does not need to be removed.
6.5 Spring Start Up
It is recommended the water be manually chlorine-shocked when first starting up the pool in the
springtime. Test water, and add the appropriate chemicals to balance the pool water per the
levels recommended in this manual. See "Water Balance and Chemistry Recommendations" on
page 5. Be sure to check salt and Cyanuric acid (stabilizer), bringing those readings up to the
recommended levels. It is also a good idea to inspect the cell, manifold screen, and test the Tri-
sensor flow switch; clean and / or replace those items as necessary. See "Removing / Inspecting
/ Cleaning Tri-sensor" on page 12. See "Servicing the Cell" on page 14.