4444----1111----4 HP adjustment
4 HP adjustment
4 HP adjustment
4 HP adjustment
This printer has function of automatic HP sensor adjustment.
The learned adjustment is registered in printer therefore not necessary to
make the adjustment as long as using same paper.
Note : Please make sure to do HP sensor adjustment in case of changing
paper.
Procedures :
Procedures :
Procedures :
Procedures :
In case of using Die Cut label.
(1) Load label and ribbon and turn on power switch to show ‘Ready’ on LCD.
(2) Select ‘Label Type’ to ‘Die Cut’.
A) Press PAUSE to show ‘Pause’ on LCD.
B)
Press MENU several times to show ‘Label Type ‘.
C)
Select ‘Die cut’ by using .
D)
Press ENTER to fix.
E) Press PAUSE to show ‘Pause’ on LCD.
(3) Executing HP adjustment.
A) Press PAUSE and show ‘Pause’ on LCD.
B) Press CALIBRATE LEVEL
to show ‘Learn Gap Level / 060 mm’.
( The default is 60 mm)
C) Set the value to length of “Label 20 mm” by using .
D) Press ENTER to execute the HP level adjustment.
E) The LCD shows ‘Learn Gap Level / BUSY !!’ and feed labels.
The printer starts calibration of the label successively in case
the ‘Measure Label’ mode is set as ‘Every’ or ‘Manual’.
The LCD shows ‘Measure Label / Busy !!’ and feed several labels.
F) LCD shows ‘Ready’ as completing HP adjustment.
Please refer “Chapter 6 Errors” in case of error appearance.
