3333----6 Procedure of operation
6 Procedure of operation
6 Procedure of operation
6 Procedure of operation
The contents in
represents front panel button and ‘ ‘ represents
LCD display.
3333----6666----1 Operation with Die cut label
1 Operation with Die cut label
1 Operation with Die cut label
1 Operation with Die cut label
The followings are the procedure for using Die cut label for the first time after
purchasing the printer or different size of Die cut label.
1) Connect power cable to the printer.
2) Connect interface cable to the host PC.
3) Load Die cut label and thermal ribbon to the printer.
4) Turn power switch on.
5) Check if the LCD shows “Ready”.
6) Execute HP level adjustment and calibration.
A) Press PAUSE to show ‘Pause’ on LCD.
B)
B) Press CALIBRATE LEVEL to show ‘Learn Gap Level / Sensing 60 mm’.
(Note : 60 mm is default value)
C) Change the value to the length of “Label 20 mm) by
D) Press ENTER to execute the calibration. The printer starts feeding
several labels for the calibration and goes back to ‘Ready’.
Note : Please refer “Chapter 6 Errors” in case of error occurrence.
7) The printer starts printing as it receives data from host PC.
Note : Please refer “3-7 Test Print” for executing the test print.
From next time, the printer will goes to ‘Ready’ as you turn on the power
switch as long as using same label.
