Chapter 2 Environment
Chapter 2 Environment
Chapter 2 Environment
Chapter 2 Environment
2-1
Please try to install the printer with following conditions.
1. Stable leveled place.
2. Ventilated
place.
3. Temperature of 10 to 35 centigrade and humidity of 20 to 80%.
2-2
Please do not install the printer in the conditions below to avoid being
defected as the printer is composed by precision parts.
1. Direct
sunlight
2. Grime and dust
3. Rapid temperature change
4. Rapid humidity change
5. Near
flame
6. Near
water
7. Near volatile material
8. Near air conditioner
9. Near
Humidifier
10. Vibrations
2-3
About power supply
1) The voltage range : AC100 to AC260 50/60Hz. ( Switchable power supply)
2) Do not take power from source that might generate noise. (Such as Motor).
2-4 About
environment
1) Operating temperature is 5 to 40 centigrade.
Prevent condensation by keeping relative humidity under 85 % RH.
2) Install the printer on leveled place with no vibrations.
3) Do not block the ventilation on of printer. Try to leave the space of at least 5 cm
around the printer.
4) Never do a polishing work using a grinder or a sand paper beside your printer.
The printer hates dusts, especially, such as high hardness dusts, sands, metallic
dust particles, because they might cause the failure of a print head. Pay careful
enough attention to avoid the above dusts. Also, never use your printer in a
dump place or in a dusty place having an oil/iron content dust.
5) Please do not install the printer near TV or radio. The electric wave might
cause some noise to the equipment.
6) In case of using the printer under the condition where electrostatic occurs,
please try to use equipment like “Electrostatic prevention mat” to prevent
the electrostatic.
