Automatic Technology iOpener RD40, Руководство по установке

Страница: 9 / 16

9 www.diyopner.com.au
13
fi g
14 fi g
WARNING! Adjusting the Safety
Obstruction Force to excess may cause
SERIOUS INJURY and/or DAMAGE.
The force setting changes how much power
is applied to the door. The force can be
increased or decreased depending on the
specifi c installation.
To Adjust Force Pressure
Hold down FORCE MARGIN SET (Fig.
13)
While holding the FORCE MARGIN
SET button, press the OPEN or CLOSE
button. Each press respectively increases
or decreases the force margin.
The OPEN LIMIT LED or CLOSE LIMIT
LED will fl ash each time the OPEN OR
CLOSE button is pressed to indicate a
force change
Test the again as per the above steps
To Recall Factory Set Force
While holding down the FORCE MARGIN
SET button, press the SET button for two
(2) seconds.
(Fig. 14)
Release both buttons. The default is
recalled.
To Recalculate Force Margins
Press and hold the SET Button for two (2)
seconds,
(Fig. 15).
The door will open and close up to 4
times to re-calculate force margins.
a.
b.
c.
d.
a.
b.
a.
b.
STEP #5 STEP #5
(continued) (continued)
Check the Safety Obstruction Force