Automatic Technology iOpener RD40 Скачать руководство пользователя страница 2

2

iOpener™ RD40 

Owner Installation Instructions

While garage doors look safe, they can be VERY dangerous if 

not handled properly.  They contain springs that under extreme 

tension and must be handled VERY carefully to avoid injury

Please take a moment to read the below notes.

The garage door must be 

well balanced.

 Sticking or binding doors must be repaired by a 

qualifi ed garage door installer prior to installation of the opener.

The unit should be installed so that it is protected from the elements. It should not be exposed to water or 
rain. It is not to be immersed in water or sprayed directly by a hose or other device.

Remove or disengage

 all garage door locks and mechanisms prior to installation of the opener.

CAUTION:

 If your garage has no pedestrian entrance door, an emergency access device should be installed. 

This accessory allows manual operation of the garage door from outside in case of power failure.

For 

ADDITIONAL SAFETY 

protection we 

STRONGLY 

recommend the fi tting of Photo Electric (PE) Beams. 

In most countries P.E. Beams are mandatory on all garage doors fi tted with automatic openers. For a 
small additional outlay Automatic Technology recommends that PE Beams be installed with the automatic 
opener ensuring additional safety and peace of mind.

DO NOT

 operate the opener unless the garage door is in full view and free from objects such as cars and 

children/people. Make sure that the door has fi nished moving before entering or leaving the garage.  Make 
sure that the door is fully open before driving in or out of the garage and fully closed before leaving the 
driveway.

DO NOT 

operate the opener when persons are near the door. Children must be supervised at all times 

when the opener is in use. 

Serious personal injury

 and/or property damage can result from failure to follow 

this warning.

Regularly check to ensure the 

safety obstruction force

 is working correctly, and 

tested

 and set as per 

this 

manual

. Failure to follow this instruction could result in 

serious personal injury

 and/or property damage.

DO NOT

 disengage the door opener to manual operation with children/persons or any other objects 

including motor vehicles within the doorway.

The door opener is not intended for use by young children or infi rm persons without adequate supervision. 
Children should be supervised to ensure that they do not play with the remote transmitters or the opener.

Keep hands and loose clothing 

clear

 of the door and door opener at all times.

Regularly examine the door, particularly cables, springs and mountings for signs of wear, damage or 
imbalance. 

DO NOT 

use if repair or adjustment is needed, as a faulty or an incorrectly balanced door may 

cause injury. 

DO NOT 

attempt to repair the door yourself as hardware is under extreme tension.

Connect the opener to a properly 

earthed

 general purpose 240V mains power outlet installed by a qualifi ed 

electrical contractor.

Only 

experienced

 service personnel should remove covers from the opener.

In order for the iOpener™ to 

sense

 an object obstructing the door way, some 

force

 must be exerted on 

the object. As a result the object, door and/or person may suffer 

damage

 or 

injury.

If the power supply cord is damaged, it 

must

 be replaced by an Automatic Technology service agent or 

suitably qualifi ed person.

Important Safety Checks

STEP #1

STEP #1

Содержание iOpener RD40

















Отзывы: