Automatic Technology iOpener RD40, Руководство по установке

Страница: 4 / 16

4 iOpener™ RD40 Owner Installation Instructions
Fitting The Opener
1 - Prepare The Door
Adjust tight or twisted guides/tracks
Clean the guides if there is any oil or wax
present using a suitable white spirit. The
only lubricant suitable for use on door
guides is silicon spray.
DO NOT use
WD-40, RP-7, petroleum grease, or
similar.
Install the locking bar covers if there
are locking bar holes in the guides.
(Fig.02)
Affi x the supplied warning labels where
they are clearly visible on the inside of
the door.
IMPORTANT NOTE - Do not lock your
door with the locking bars after installing
the opener. Remove or disable the lock.
Security is not affected as the opener has
an inbuilt locking facility.
2 - Fit the Weight Bar
If the door has a handle:
Remove the door handle
Fit the weight bar and refi t the handle
using the provided fasteners
(Fig.03) .
If the door does not have a handle:
Locate the centre of the door at the
bottom rail.
Place the weight bar at this point and
mark the two positions where the
fasteners will go
Drill the two 4.5mm holes in the door
and fi t the weight bar using the fasteners
provided.
(Fig.04) .
Check that the door is still balanced
and smooth. If not, then the door may
require servicing.
a.
b.
c.
d.
a.
b.
a.
b.
c.
d.
02 fi g
04
fi g
03
fi g
STEP #3 STEP #3