Automatic Technology iOpener RD40, Руководство по установке

Страница: 14 / 16

14 iOpener™ RD40 Owner Installation Instructions
Symptom Possible cause Remedy
Door will not operate Mains power not switched on.
Door is obstructed.
Door is locked or motor jammed.
Door tracks/hardware damaged.
The opener is in “vacation mode”
Switch on mains power.
Remove obstruction.
Unlock door or remove jam.
Door requires service/repair by
qualifi ed technician.
Turn off “vacation mode”.
Door starts to close but
automatically reverses to open
position Adverse weather conditions (wind
or cold) causing door to stiffen and
become tight in the tracks.
Possible obstruction in the
doorway.
Increase force margin setting
See page 9 or re-calculate force
margin.
Remove obstruction.
Door operates from drive unit
(OPERATE) button but not from
transmitter*
See note
Transmitter code not stored in
memory.
Flat battery.
Broken battery lead inside
transmitter
Code transmitter in to openers
memory. Refer step # 6 on page 10
Replace battery
Send transmitter to installer or
Automatic Technology for repair
Door will not close fully. Door limits positions need to be
reset. Reset limits positions. Step # 4 on
page 7.
Door will not open fully. Door limits positions need to be
reset. Reset limits positions. Step # 4 on
page 7.
Courtesy light not working Globe down Replace globe
Globe keeps blowing Incorrect globe voltage - must be
240V AC Replace globe
PLEASE NOTE:
Some areas may be prone to excessive radio interference brought on by devices such as cordless telephones,
wireless stereo headphones and baby monitors. It is possible that these devices could cause a degree of
interference such as to greatly reduce the range of the transmitter. In such an instance please contact Automatic
Technology. As this is not a warrantable situation but an environmental issue charges may apply.
Troubleshooting