Automatic Technology iOpener RD40, Руководство по установке

Страница: 7 / 16

7 www.diyopner.com.au
Set The Travel Limits
09
fi g
10 fi g
6 - Set Travel Limits
Move the door to half way open by hand.
If the door will not move, disengage the
opener by pulling the cord’s handle down
(Fig. 09) .
Pull the handle to re-engage the opener.
Turn on the power to the opener. The
CLOSE LIMIT LED will be fl ashing.
Press and hold the CLOSE button - the
door should starting closing
(Fig. 10) .
If the door opens, release CLOSE and
press the OPERATE button once to
change the motor’s direction.
Use the CLOSE button to edge the door
down until it just touches the ground.
The rubber strip at the bottom of the
door should form a good seal with the
ground.
Release the CLOSE button when the door
is near the desired closed position.
When the door is at the desired close
position, press the SET button The OPEN
LIMIT LED will now fl ash.
Press and hold the OPEN button to open
the door Release the OPEN button when
the door is at the desired open position.
It is recommended this is just short of the
upmost open position.
WARNING! Once the next step is
performed, the door will automatically
close and open to calculate force settings.
Keep persons and objects clear of the
door until it stops.
Press the SET button to store the open
limit.
Please read the above warning.
Resetting Travel Limits
To reset the limits press and hold CLOSE for
6 seconds until the CLOSE LIMIT LED fl ashes
quickly. Then repeat steps outlined above.
If no action is taken within 30 seconds, the
opener will return to normal operating mode
and restore the original settings.
a.
b.
c.
d.
»
e.
f.
f.
g.
h.
STEP #4 STEP #4