Automatic Technology iOpener RD40, Руководство по установке

Страница: 6 / 16

6 iOpener™ RD40 Owner Installation Instructions
5 - Mounting the Opener
If the drive gear does not rotate by hand
freely, switch the opener to manual by
pulling the disengagement cord (there
will be a click). Test this by trying to
move the plastic drive works by hand.
Slide the opener over the door axle and
into the drum of the door
(Fig. 07) .
Push the opener in as far as possible
(without interfering with the curtain) so
one of the door drum’s wheel spokes is
between the opener’s drive forks.
Re-attach the door bracket using your
reference marks as a guide and tighten
the bolts. Ensure the opener mounting
slots align with the slots in the door
bracket.
(Fig. 08) .
If the bracket cannot be relocated,
the opener may be fi tted onto the
axle using the opener’s saddle and
U-bolt as follows:
Using your reference marks as
a guide, sit the opener on the
door mounting bracket and
secure with the opener’s U-bolt
and saddle and tighten fi rmly.
Adjust the door position (if
necessary) on the brackets so
that the door feeds smoothly
into the guides. Make sure that
the centre of the door doesn’t
hit the lintel and that the curtain
is not pushed forward hard into
the guide.
Remove the support and safety ropes
Connect the power cord to a suitable
power point, but
DO NOT SWITCH
ON .
Secure the power cord away from any
moving object (e.g. the door) with the
cable clip supplied.
With the opener still disengaged, pull
the door up and down to make sure it
runs freely
a.
b.
c.
d.
»
i.
ii.
e.
f.
g.
h.
07 fi g
08 fi g
Fitting The Opener
STEP #3 STEP #3
(continued) (continued)