Automatic Technology iOpener RD40, Руководство по установке

Страница: 3 / 16

3 www.diyopner.com.au
Pre-Installation Checks
01 fi g
Tools Required
Ladder
Adjustable wrench
Socket set
Drill
Screwdrivers
Marker pen
Door stand
Door Operation
The door must be in good operating
condition.
The maximum effort to move the door
up or down, from stationary, should not
exceed 20kg of force at the bottom rail.
Lift the door to about halfway. When
released, the door should remain stationary
and not slide up or down.
Raise and lower the door to check for
binding or sticking.
Unsuitable Door Types
Do not install the opener on doors with:
removable mullions (used between
two adjacent doors)
that incorporate a wicket door (small
hinged door in the garage door’s
curtain)
axle diameters that exceed 35mm
Position
The opener can be installed on either the
right- or left hand side of the door.
This opener must be installed in a dry
position that is protected from the
weather.
•
•
•
•
•
•
•
•
•
•
Power Supply
Properly earthed 3 pin single-phase power is
required.
WARNING! A portable power generator
is not recommended due to spikes,
surges and fl uctuations in the supply.
Side room
The minimum side room required from the
edge of the door curtain is 40mm to the inside
of the door bracket, and 85mm to the wall
(Fig. 01) .
If the all of the above
requirements are not met,
please contact a garage door
professional:
(p) 1300 300 625
(w) www.diyopener.com.au
STEP #2 STEP #2