Owner Installation Instructions
Dual Gate Controller DCB-05
21
Menu 4. Lock times
The Dual Gate Controller’s lock function can be programmed for both hold and pulse operation. The lock output
can also be programmed to activate prior to the motor starting. The open cycle and close cycle actions can be
programmed differently. The lock can be either OUTPUT1 or OUTPUT2 (see OPERATING MODES).
Parameter
Min
Max
Default
Step
Unit
Menu No.
OPEN LOCK TIME Set the time the lock is
activated for on open cycles
0.0
Hold
0.5
0.1
Sec
4
CLOSE LOCK TIME Set the time the lock is
activated for on close cycles
0.0
Hold
0.5
0.1
Sec
4
PRE-OPEN LOCK TIME
Time the lock is activated for prior to opening
0.0
25.5
0.0
0.1
Sec
4
PRE-CLOSE LOCK TIME
Time the lock is activated for prior to closing
0.0
25.5
0.0
0.1
Sec
4
Menu 5. Light times
The Dual Gate Controller’s light function can be programmed to operate a courtesy light or a warning light.
The time the light stays on for after a cycle is adjustable. The light can also be activated prior to the gate
moving so that a warning can be given of the pending movement. Note the light output can be selected to be
either OUTPUT1 or OUTPUT2. The parameters are shown below.
Parameter
Min
Max
Default
Step
Unit
Menu No.
ON AFTER CYCLE LIGHT TIME
Time light remains on for after a cycle
0
255
60
1
Sec
5
ON BEFORE OPEN CYCLE LIGHT TIME
Minimum time light is activated for prior to
opening
0
255
0
1
Sec
5
ON BEFORE CLOSE CYCLE LIGHT TIME
Minimum time light is activated for prior to
closing
0
255
0
1
Sec
5
Menu 6. Motor settings
Motor speed
The motor settings adjust various aspects of the gate travel. When a single gate installation is used the
SYNC DELAY TIMES and M2 settings are ignored. The default value for the CLOSE SYNC DELAY time is
automatically calculated for LIMIT SWITCH/AMP TRAVEL installations. The value calculated is selected so that
the delay between M2 and M1 reaching the close position is equal to the OPEN SYNC DELAY TIME. The MAX
OVERRUN TIME is set to 0 for TIMED TRAVEL installations.
Dual Gate Controller adjustments
(cont.)
