30
Dual Gate Controller DCB-05
Owner Installation Instructions
Remote code set procedure
If a transmitter is already coded into the opener,
additional transmitters can be coded without being in
direct contact with the Dual Gate Controller.
NOTE:
Only the function of the existing transmitter
button can be assigned to new transmitter. Please read
instructions prior to proceeding - there is a time-out
facility for security reasons.
1. Selecting the function to be coded
Using the existing transmitter, operate the gate with
the transmitter button which has the function to be
coded
(Fig. 55)
(e.g. Button 1 has been coded with the
OSC function assigned).
2. Wait for gate to complete cycle
If the button’s function activates the gate (PED, SWP,
OSC, CLS, STP or OPN) wait for the gate to complete
its cycle.
3. Activate remote code set mode
Using a small pin press and hold through the Coding Hole
of the existing transmitter for two seconds
(Fig. 56).
4. Code new transmitter button
Within 10 seconds, press the button on the new
transmitter you wish to code for 2 seconds
(Fig. 57)
.
5. Confi rm transmitter button to be coded
Press the same button again (within 10 seconds)
for confi rmation.
6. Test operation
The new transmitter button should now function as the
existing transmitter.
NOTE:
When a transmitter is remote coded, its ID label
is set to that of the existing transmitter. If the existing
transmitter does not have an ID label assigned, then
the ID label of the new transmitter is set to: R/C Tx ###,
where ### is the existing transmitters store number.
This ensures that the originator of any remote coded
transmitter can be identifi ed.
55
fi g
56
fi g
Existing
transmitter
New
transmitter
PRESS
PRESS
Existing
transmitter
57
fi g
