Automatic Technology DCB-05, Руководство пользователя

Страница: 13 / 40

Owner Installation Instructions Dual Gate Controller DCB-05 13
Step 2. Confi rming Ready To Start
The Dual Gate Controller will prompt you to confi rm
that the motor wiring is complete
Fig. 08 and that the
gate(s) are in a halfway position and engaged. Press SET
to confi rm
Fig. 09
Step 3. Confi rming Correct Wiring Detected
The controller will now automatically detect the type
of drive unit used by the number of wires used. If the
correct number of wires is displayed
Fig. 10 then press
SET to continue otherwise press EXIT and check the
wiring. Continue From Step 4a page 14 For 2 Wire
(Amp Travel) Setup.
Step 4. Confi rming Motors Detected.
The controller will now automatically detect if one or
two motor are connected. If the correct number is
displayed then press SET to confi rm. Otherwise press
EXIT and check the wiring
Fig. 11 .
Step 5. Adjusting Close Limit(S)
The controller will now prompt for the motor(s) to
be driven to the desired close limit and for the limit
switches to be adjusted so that the motor stops at the
desired position. The motor can be driven using the UP
and DOWN buttons on the console keypad or Button
1 and 4 of a transmitter. After making adjustments to
the limit switch positions always re-approach the limit
at full speed by driving the motor open a short distance
and then driving it close again. When the close limit has
been adjusted press SET to continue
Fig. 12 .
Note: If the motor drives in the wrong direction (UP
closes gate / DOWN opens gate) the motor wires need
to be swapped.
Step 6. Adjusting Open Limit(S)
The controller will now prompt for the motor(s) to
be driven to the desired open limit and for the limit
switches to be adjusted so that the motor stops at the
desired position. The motor can be driven using the UP
and DOWN buttons on the console keypad or Button
1 and 4 of a transmitter. After making adjustments to
the limit switch positions always re-approach the limit
at full speed by driving the motor close a short distance
and then driving it open again. When the open limit has
been adjusted, press SET
Fig. 13 .
Step 7. Automatic Profi ling
After a brief pause the controller will automatically close
and open gate several times and learn the gates load
and travel characteristics. When the setup is complete
the MAIN SCREEN will be displayed with the gate
shown to be OPEN. The Gate can now be used.
10 fi g
Half Open Gate &
PREV NEXT
EXIT
SET
Engage Mtrs, Set
PRESS
09 fi g
Motor=2/3/5 Wire
PREV NEXT
EXIT
SET
Press Set If OK
PRESS
M1&2 Detected
PREV NEXT
EXIT
SET
Press Set If OK
PRESS
11 fi g
Setting travel limits (cont.)
Selecting Limit/AMP Travel Setup
Confi rming Detected Motor Wiring
Confi rming Detected Motor Wiring
PREV NEXT
EXIT
SET
Close Limit,Set
M1,2 & Adjust
OR PRESS
PRESS
Adjusting The CLOSE LIMIT
12 fi g
PREV NEXT
EXIT
SET
Open Limit,Set
M1,2 & Adjust
PRESS
OR
PRESS
Adjusting The CLOSE LIMIT
13 fi g